- Very good Au-Cu intercepts, but mineralisation is deep (>500m).
- Bad location
- Ecuador, need I say more....
- Local access issues?
- Why no backing from a major company? With the reported grades you could expect a more adventurous major taking an interest to playing the long game?
- Why is no future drilling planned for any of the other targets?
- Are the great intercepts skewed by the fact that the holes are nearly vertical and been drilled into a vertical deposit?
- If the Aguinaga targets is key (heck they even have an open pit outline on their geofizz anomaly), why no drilling planned on it this year?
I was intrigued, a small ASX and AIM listed company with a $0.1 share price (or 6p in old world money) and a $80-90M market cap (ahh a normal ASX listed company where a tight float is if you have less than a billion shares issued).
So I went through the project data all the way back to 2013 and brought as much data as I could find so I could review it and to separate the reality from IR spin. This was hard to do. There was a lot of fluff in the press releases, but some nice photos which were very informative.
This is understandable as they have been drilling some very deep drill-holes (up to 2000m) and these holes take a lot of time to drill (2-3 months per hole), and the company, understandably, wants a continued stream of news from their , but it made it a challenge to find out true hole depths, azimuths and so on....
But I have my ways (and a bit of basic trigonometry helped), and here is what I could extract and share with you, and I've also included their proposed drill-holes (azimuths and depths are educated guesses).
At first glance hey aren't too bad, I thought I had found a decent project with good upside.
|left = PR results; right = split assays|
|left = PR results; right = split assays|
All of the drilling to data (18 holes for 23,700m drilled) into the Alpala target and they have defined a 500m x 500m x 1500m (vertical extent) zone of porphyry Cu-Au mineralisation. But, darn, the high grade stuff is really deep, starting at around 500+m depth.
When I looked at the data I noticed that most of the drill-holes were almost vertical and you combine this with what looks like a vertical deposit you get to understand why the grades they have been reporting are so good.
They have hit some low-moderate grade (0.25 g/t Au and 0.25% Cu) mineralization near surface, but it is thin (250m x 125m), and what do they photos show us?
As you can see those rocks aren't beautiful shades of green, and Sol Gold nicely tell you multiple times that they have bornite and chalcopyrite at surface. So no nice and cheap to mine and leach oxide ore. We can ignore this, it is too small, too low grade.
The value in this deposit is the high(ish)-grade mineralisation at depth, and Sol Gold nicely show us their conceptual 6km ramp that will run below their Aguinaga target to below Alpala, which is nice.
Often you can tell a lot about a project by what isn't being told. All of the drilling is focused into a small 650m x 550m area.
|Red blobs = good! Yellow blobs = drilled holes.|
When we look at their proposed phase 2 drilling, again, all of them are focusing to drill into the area of known mineralisation, no holes appear to be planned for any of the other targets. Why is this?
|Nice and adventurous!|
You would think that they would plan a couple of drill-holes for some of their other targets that have similar (or better) exploration results? All we see in the PRs are a few surface samples and a single trench.
When you look at the planned holes, they aren't being drilled from the optimal locations, and we have multiple holes being drilled from the same platform, often where holes historic holes have been drilled (some platform recycling - cuts down on prep time and reduced the footprint of the drilling).
So for the phase 2 program only a single new platform is being built? No holes are planned for other targets? There could be a number of reasons:
- Sol Gold only has access to a small part of the property. This could be very bad news as it could mean that there is local resistance to the project.
- This could be minor - the company hasn't started dialogue with communities adjacent to Alpala.
- Major - the local communities are anti-mining. if that is the case. the project is dead.
- They don't have permits to drill/explore other areas - basically they are continuing to work within the limits of the current environmental permit that may have a limit on the number of pads (but not drill-holes) that can be built.
- Minor - this basically takes time (and money).
Leapfrog viewer link here
One to keep on your radar.